KJSYSTEMS Inc. · Standby generators in Eagle Mountain, UT
KJSYSTEMS installs whole-home standby generators and portable generator hookups in Eagle Mountain, Cedar Valley and Utah County. One crew holds the plumbing license for the gas line and the electrical license for the transfer switch, so the job is permitted and finished without a second contractor. Standby generators from $11,995 installed; portable hookups from $1,995.
Water running or power out? Skip the form and call (801) 669-2788.
Plumbing · Electrical · Heating & Air · Backup Power
Essential-load planning, permitted transfer switches and gas lines, by one licensed crew based in Eagle Mountain.
Backup power services
Standby Generator Installation
A natural gas or propane standby generator that starts itself when the grid drops, sized from the loads you choose to keep: furnace, well pump, sump pump, refrigerator, medical equipment, internet.
Standby generators from $11,995
Portable Generator Hookup
A permitted inlet box with a manual transfer switch or interlock, so your portable or RV generator powers the circuits you pick without extension cords through windows.
Generator hookups from $1,995
Generac and Kohler Generators
Generac and Kohler home standby units with the gas line sizing, pad, transfer switch and start-up handled by one licensed plumber and electrician team.
Ask about brands and sizing
Generator Repair and Maintenance
Annual service for existing standby generators: oil and filter, battery, load test and transfer switch exercise, plus repair when a unit fails to start.
Service plans quoted in writing
Straightforward pricing
Typical Wasatch Front installs. We confirm your exact price in writing after a quick look at your home.
Portable / RV generator hookup
inlet + interlock
$1,995 to $2,695
Whole-home standby generator
installed
$11,995 to $18,995
Prices shown are starting points for typical installations and are not a quote or offer. Your final price depends on equipment, gas and electrical capacity, run lengths and site conditions, and is confirmed in writing after a site review. Permits, utility fees and applicable sales tax are additional. Prices subject to change.
Common questions
Start by listing what must stay on during an outage. A furnace, refrigerator and a few lights fit a portable generator with a permitted hookup from $1,995. A well pump, A/C, medical equipment or a home office usually calls for a whole-home standby unit from $11,995 that starts itself.
Installed standby generators run $11,995 to $18,995 depending on size, fuel and the transfer switch. The price is confirmed in writing after a site review. Permits, utility fees and sales tax are extra.
A gas standby generator needs a licensed plumber for the gas line and a licensed electrician for the transfer switch and wiring. KJSYSTEMS holds both licenses, so one crew does the whole job under one permit set, with no hand-off between contractors.
Yes, where natural gas service is available; propane is the alternative for homes without it. We check meter and line capacity before sizing the unit so the generator, furnace and water heater can all run at once.
We check panel size and existing load before recommending anything. Many newer Eagle Mountain homes have 200A panels that accept a transfer switch directly; older or crowded panels may need an upgrade, which the same crew does.
Most portable hookups are done in one visit. A standby generator takes a site review, permit, pad and gas and electrical work, typically one to two days on site once the equipment arrives.
Shut off the main water valve if you can, then call: plumbing, power or heat.
Get in touch
If water is running or the power is out, call. Don’t fill out a form. For anything you’re planning, either works.
Phone · Call or text
Answer what you can. We’ll get back to you.
We use your details to answer your request. Nothing else.
